![]() How to Replace a Starter on a Tanning Bed.Why Does the Tanning Bed Make You Happy?.How do I Troubleshoot Sunquest Tanning Beds?.Frequently Asked Questions About Tanning Beds.How to Remove Acrylics in a Tanning Bed.Use this outlet as a dedicated outlet solely for the use of the tanning bed. Plug the 120-Volt AC power cord into an outlet. ![]() Tighten the threaded locking ring to secure it in place. Align the terminals and firmly push until the cords are connected. This will also lubricate the gas springs. To verify that the gas springs are working, lift and lower the canopy a few times. Have someone hold the canopy of the bed open while you align the ends of the gas spring ball joints with the pivot studs and push them into place. Remove the locking clip and then install the gas spring. Locate the mechanism on the gas springs that causes them to lock. Tighten the bolts into the end-cap threaded inserts until snug. Insert the bolts with nylon washers into both hinge brackets. Lift the canopy of the bed and place the hinge bracket between. Install the bushings into the hinge brackets. Secure using the included bolts and Allen wrench. Install the hinge brackets to the ends of the bench. ![]() Use these bolts and washers, attach the stand legs. Remove the six bolts and washers that come installed in the bench. Lay the bench upside down on the floor and find the two stand legs. Pull the canopy from the packaging in the same manner. ![]() It would be best if you had help for this step. Simply remove the plastic sheets and pull the bench from the carton bottom. The remainder of the assembly should only take about 20 minutes for one person. According to Wolff Tanning Beds, the beds are delivered on an 18-wheeler, 98 percent pre-assembled. SunQuest Pro tanning beds are delivered to the client almost fully assembled. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |